- Joined
- Aug 18, 2022
- Messages
- 79
- Reaction score
- 104
I got my smokeless back from McGowen this past week, after opening up my stock and getting that all together I have now started tinkering with the swinglok sizing die. I have watched a few video about setting up and testing the bullets. Would it be best practice to foul the barrel with a couple primers before going to far into this? What I have found with my barrel so far is that the bullet will be tight to get started then there is a loose spot in the finale 2/3 inches of the barrel then does get tighter as the bullet goes down the barrel. I have sized a couple fury bullets that load with "2 finger" pressure. Is it common for the bullet to be difficult to start? I did squeeze 1 bullet down to small and it dropped right to the breech. Just trying to shorten my learning curve here. TIA