- Joined
- Mar 3, 2024
- Messages
- 295
- Reaction score
- 335
I am planning to load for 9.3x74R ammo. Anyone have some brass, once fired or virgin, for sale. Please PM me.
Sold already. Missed it
Found ten boxes of 9.3x74R! Cheap! I may be pulling some bullets and reloading at a lighter load. Looking for data for lighter. What powder and amount. Got a Forster co ax setup and have most of the pieces to begin reloading.
Very helpful! I will be hunting this powder. I have several hot cartridges. Tame them down!See if you can find load data using H4895, then read up on the 60% rule with this powder https://hodgdonpowderco.com/wp-content/uploads/2023/04/h4895-reduced-rifle-loads-2.pdf
Very helpful! I will be hunting this powder. I have several hot cartridges. Tame them down!
Good luck finding H4895. One might get lucky & find IMR4895See if you can find load data using H4895, then read up on the 60% rule with this powder https://hodgdonpowderco.com/wp-content/uploads/2023/04/h4895-reduced-rifle-loads-2.pdf
Good luck finding H4895. One might get lucky & find IMR4895
No No and NoMaybe a dumb question, but if I pull the bullet and dump the powder from my loaded 9.3x74R rounds, weigh it and put 60% back in would that work?
No. Some powders are position sensitiveMaybe a dumb question, but if I pull the bullet and dump the powder from my loaded 9.3x74R rounds, weigh it and put 60% back in would that work?
Shooter reference has data for 250 gr bullet with imr4166 with low pressure ang velocity at 1886 fps and imr4350 with lower pressure than the 4166 with 2072 fps which should work with 250 gr bullet also data for 270 and 285 gr bulletsMaybe a dumb question, but if I pull the bullet and dump the powder from my loaded 9.3x74R rounds, weigh it and put 60% back in would that work?
BTW, if you are shooting a 9.3x74r double rifle, reduced loads will not shoot to the sights. The rifles are regulated at the factory to shoot a specific bullet weight, at a specific velocity range.Glad I asked. I would not have done so without supervision! I know a local guy who can help me get the right procedures. Still assembling my reloading setup.
Yes, it IS anO/U double. Didn't know this. Will reduced loads will just hit low? Or just anywhere?BTW, if you are shooting a 9.3x74r double rifle, reduced loads will not shoot to the sights. The rifles are regulated at the factory to shoot a specific bullet weight, at a specific velocity range.
Yes, it IS anO/U double. Didn't know this. Will reduced loads will just hit low? Or just anywhere?
Enter your email address to join: